How Do I Make A Jig For Cabinet Handles

Measure Where You Want the Handles Place the cabinet pull against a door where you want it and measure how far the lower hole should go from the bottom and the side edge 3 from bottom 1-14 from edge on my doors.

How do i make a jig for cabinet handles. Hold the handle against the jig so you can see which holes to use. Drill through the front of the door at your mark. How To Make a Jig For Cabinet Hardware To make the jig the first step we did was to measure the width of the stile mark the center point measured the handles then with a tape measure we marked the handle length on the cabinet stile.

Double check your measurements. This means dividing the drawer into thirds and placing the pull hardware horizontally in the center of each left and right section. Fix the tow sliders at the corresponding distance.

You can see in this instance that the first hole and the fourth hole corresponds with a 96mm hole centre of this particular handle. DIY Cabinet Hardware Template. The beauty of this jig is that it can be turned sideways and used for the cabinet doors as well.

Step 1 Decide exactly where you want your hardware to go on the cabinet. We took the cabinet door off and set our cabinet door up at the drill press and drilled straight holes. Setup your cabinet hardware jig to the desired hole locations.

Make this simple jig to get the hole placement right every time. Record this 1st measurement. There are two main professional options on the market now cabinet hardware templates and cabinet hardware jigs.

Cabinetmakers fabricate several cabinet drawer jigs for different sizes of drawers. Another option with heavier and larger drawers is to use a larger cabinet pull to cover more of the drawer front. You can make your own template by screwing two 1x1 pieces of scrap wood in a T pattern to a piece of thin plywood.