How Do You Install Cabinet Handles

The ideal template for installing door handles and drawer pulls is made from two pieces of 14-inch plywood attached to a wooden core to form a U shape.

How do you install cabinet handles. For a truly recessed handle typically all it takes to secure the handle in place is a slow curing epoxy. Install cabinet pulls without using a jig by imagining that your cabinet is divided into four quarters and placing the knob in between the middle two. This type of installation requires patience and attention to detail with mistakes being hard to correct.

Your kitchen cabinet handles should be. For upper cabinets this is the lower corner. Do not over-tighten the clamp it only needs to be tight enough to hold the handle in the right position until the epoxy cures.

If you are changing your kitchen cabinets from knobs to handles then you need to drill 2 new holes and fill in the hole from the knob. Slip the template over the edge of the door or drawer front position it where you want it and drill the hole. Apply some epoxy to the back of the handle and clamp it in place.

Measure the width of your pulls and mark the center of the cardboard for a uniform stencil. Most cabinets are not pre-drilled to accept handles or pulls. Step 2 - Use a tape measure to mark the holes that you will drill in the door.

Installing cabinet hardware can be intimidating and overwhelming but it doesnt have to be with this little tip. Read the directions if your hardware came with any. Alternatively cut the exact size of your cabinet or drawer face from a piece of cardboard.

Measure 2 12 or 3 inches in from one edge of a piece of squared-off cardboard and from the adjacent edge measure in half the width of the cabinet stile. I make the guide jig using a 6x10x12 scrap piece of plywood with 2 61x2s glued and nailed to 2 sides to create an L. Holes must be carefully drilled to allow for installing specific cabinet hardware.