How Install Soft Close Drawer Slides

Align The Drawer Slides.

How install soft close drawer slides. You need to completely take it out of from slide. Then for the roller drawer slides. The users need to lay down the drawer towards its side as it is very necessary that the slide should flush adjacent to the base corner of the drawer.

You simply need to press the disconnect lever to make that happen. Between the front bracket and back notch of drawer place the left slide. Repeat at the rear.

Do this for the right-side drawer slide as well. Thanks for watchingHere is the link for the Drawer slides. Start by aligning the small-sized slide adjacent to the drawer base.

Screw marked glide into place predrilling holes if desired. As you trigger this lever pull the slip out of the slide gradually. Do the same for the right-side slide too.

Mark placement with a pencil. Your slides should come with the correct screws usually 5mm x 716. Decide the Drawer Placement Mark Certain Points.

Secure the first drawer slide to the system panel using screws. Use the pre-drilled shelf holes in your panel and line them up with the pre-drilled holes in your slide. Place the drawer on its side.