How To Adjust Undermount Drawer Slides

For side-mount and center-mount slides typically measure the distance from the front edge of the cabinet to the inside face of the cabinet back and then subtract 1.

How to adjust undermount drawer slides. You need to put a set of clips in the front of the door which the slides lock into. You need to mark the pin location onto the back of drawer slide. Use this knob to fine-tune the space between the drawer fronts.

Take note of this measurement as under-mounted slides need to be the exact same length as the drawer. Supports loads up to 100 lbs. You do not have to remove it.

Pull-out shelves kitchen utensil drawers and point-of-sales trays. Next the undermount can be adjusted with various levers and adjustment knobs found on the slide remove the slide. Press up on adjustment tab 2.

14 at top and 18 at bottom are feasible with proper alignment. For drawers up to 24 wide For additional technical information see below A patented Cam Drawer Adjust allows for precise. Cutting Notches Drilling Holes.

This can be done while the drawer is installed. Bottom mount drawer slides usually require a 1 height reduction to allow the drawer to be installed using a tip in method. Calculate the drawers length to complete your measurements.

But for side mounts adjustment will require removing the slide and re-positioning the drawer slide to adjust. For under-mount slides measure the drawer length. Learn more Blum Inc.