|
How To Make A Jig For Drawer Handles
This may not be totally new content as Ive showed the jig before even though Ive never actually showed how to make it.
How to make a jig for drawer handles. To ready the jig for use draw a centerline on the drill guide and lay out the pulls screw locations from this centerline. Plywood with a slot at the top that allows him to locate the center of the drawer and its laid out so that different drawer depths can be done with the same jig. Then mark your exact hole placement on the cabinet and replicate that on your jig.
Place the plywood jig flat with the poplar sticks on the bottom. These are a cinch to make can be done with just about any thickness of wood and are a perfect project to use up scrap wood. Place the drawer knob or pull on the front of the plywood jig as if it were the drawer.
The jig is simply a piece of 14-in. The wood is glued and nailed together. How To Make a Jig For Cabinet Hardware To make the jig the first step we did was to measure the width of the stile mark the center point measured the handles then with a tape measure we marked the handle length on the cabinet stile.
Woodworking hardware DIY DONATE TO THIS CHANNEL TO HELP KEEP IT GOING. We locate the center point of our drawer front lay the slot in the jig right on the mark and just hold it in place as we drill the holes for the drawer handle. Find the center of the two holes on your jig and mark a very clear line at the top of the flat side.
Cut a scrap piece of 14-inch plywood or MDF approximately 8-inches square. Use your level and square to make sure it is square. I made an easy jig out of plywood to help me install cabinet pulls.
We took the cabinet door off and set our cabinet door up at the drill press and drilled straight holes. Place a piece of painters tape on the drawer front and mark on it the centerline of the pull. It is an easy way to consistently drill holes and can be modified to install handles on.
Source : pinterest.com