How To Measure For Replacement Cabinets

Always measure twice as we will build the custom made cabinet door or drawer front to the dimensions you.

How to measure for replacement cabinets. Click to see full answer. Extend the line along the work area. Measuring Your Cabinets With your tape measure you want to measure on the inside of the frame.

If you know the exact dimensions of the Cabinet Doors andor Drawer Fronts replacement for current door or drawer front and plan on using the same overlay hinge take a measurement of the back side of your existing cabinet door or drawer front by measuring the width first followed by the height. Measure from inside edge to inside edge and then notate that number this will be your rough opening measurement. Mark the depth of the cabinet bases on the floor.

On wider cabinets with two doors butting in the center measure the width of the opening add 1-inch then divide by 2. Make a pencil mark along the outside edge of the door on the hinge side. Position the end of the tape measure at the upper right corner and measure down to the inside of the lower right corner.

We recommend measuring at least twice for accuracy as our doors are custom made to the specific measurements you provide. Measure the distance between the pencil mark and the adjacent inside edge. If youre replacing your cabinet hardware and have pre-drilled holes in your cabinet or drawer its important to buy new pulls that have the same center-to-center distance as your old pulls.

On single doors simply measure the cabinets opening size and add 1-inch to both the width and height. Measure and note the ceiling height and any existing soffits Measure and note all wall lengths Check corner square-ness at the floor base and wall cabinet levels to determine if you will have any issues during installation. To gather these measurements run your measuring tape from right to left to record the width of the cabinet.

Need to measure your kitchen for new cabinets. The upper cabinets should be measured for their length width and depth. If you are measuring a high back drawer then order your custom drawer based on the high measurement and the normal taper will be to a 3 front height.